Rear Fender Options
#12
black fender...plastic can be cut and you can always mount the lights and plate above, but not sure if it'll look good since the 09+ rear fender sits flatter
#14
but anything could be made to fit with enough work.
#15
brilliant!! I didn't think to check the subframe part number. 2009+ have a /A appended to it.
#16
Fender
so TJrockit
have you found a solution for the 2006 klx250 rear fender?
wondering what you have done.
I think I am going to just remove all that crap and mount my plate under the red tail light, keeping stock blinkers. it will not have a white light on the plate, but might still be ok
fenderworks
glenwood springs, co
have you found a solution for the 2006 klx250 rear fender?
wondering what you have done.
I think I am going to just remove all that crap and mount my plate under the red tail light, keeping stock blinkers. it will not have a white light on the plate, but might still be ok
fenderworks
glenwood springs, co
#17
Some aluminum, a drill and some nuts and bolts. I broke mine a few times. Then cut the black plastic off even with the bottom of the tail light made some bends and drilled some holes through the cross piece. I did three but would just go with two if I were to do it again.
Thread
Thread Starter
Forum
Replies
Last Post