KLX250s WFI model - No spark
Thread Starter
|
Junior Member
Joined: Jan 2019
Posts: 18
1st Gear Member
It's not dumb, but I had the top part of the engine disassembled because of piston rings stucked in piston grooves. It was repaired, and since then I made 200km until this problem started to happen. Plus I don't have spark, so even if valves aren't ok, something about ignition isn't aswell
Thread Starter
|
Junior Member
Joined: Jan 2019
Posts: 18
1st Gear Member
https://www.kawasakiforums.com/forum...tarting-41436/
try giving this a read and see if it helps
you may have a bad wire to one of the sensors, maybe look up a wire diagram and check the wires to them.
ps when cranking your battery sounds a little on the weak side( low cranking amps)
try giving this a read and see if it helps
you may have a bad wire to one of the sensors, maybe look up a wire diagram and check the wires to them.
ps when cranking your battery sounds a little on the weak side( low cranking amps)
This are the cables that conect to ECU. The cables were damaged in the same place.
I fixed it, and right now the bike is running. Thank you all
Thread
Thread Starter
Forum
Replies
Last Post
