Handlebar/cables ????
Thread Starter
|
Junior Member
1st Gear Member
Joined: Jan 2012
Posts: 12
Handlebar/cables ????
I will be replacing my bars with ProTaper SE's and have not yet decided what bend (low,med or high). My question is, do any require new cable or just rerouting ? I am looking at going with CR Med's
Thanks in advance
Thanks in advance
Member
1st Gear Member
Joined: Mar 2012
Posts: 45
From: Bloomington, IN
I replaced mine with pro taper SE CR Hi......trimmed a half inch off each side. The cables were fine........would have been fine regardless if I had trimmed a bit.
https://www.kawasakiforums.com/forum...ods-yet-37444/
https://www.kawasakiforums.com/forum...ods-yet-37444/
Last edited by TheBigLebowski; Apr 27, 2012 at 12:38 AM.
Thread
Thread Starter
Forum
Replies
Last Post
