Thread size of pilot jet screw
Senior Member
Joined: Feb 2009
Posts: 667
From: Hayward, CA
1st Gear Member
It's metric fine, M6 x .75, not the easiest to find.
Here's one place that carries them:
Search Results - GlobalIndustrial.com set m6&x=27&y=8
Ride on
Brewster
Here's one place that carries them:
Search Results - GlobalIndustrial.com set m6&x=27&y=8
Ride on
Brewster
Last edited by Brewster; Dec 19, 2013 at 11:07 PM.
Thread Starter
|
Senior Member
Joined: Nov 2013
Posts: 181
From: Patagonia, AZ
1st Gear Member
Hmmmmm........ The answer I got from Kouba was 1 X .6. I did re-tap it to that size. Maybe that's why the Kouba adjustable screw didn't want to seat properly. If you're right, it's too bad because I also have a 1 X .75 tap.
At this point I'm buying a carb from a fellow inmate who put in a pumper. I'm afraid mine's toast.
At this point I'm buying a carb from a fellow inmate who put in a pumper. I'm afraid mine's toast.
Thread
Thread Starter
Forum
Replies
Last Post