I know the information in here somewhere but i can't find it. I need a run down on the installation of the N1TC needle. Most people are setting the clip on the second position. Is this the second groove from the top (the top beingnot the tapperd tip end)? When you place the needle in the carb does the collar go on top of or under the clip?

I also want to let everyone know that I gotmy fmf q2 and the new head pipe from Jerry at FSW this weeked. Jerry did an awesome job of adpting the slipon to his head pipe and he did the mods for free in order to sell one of his pipes.

Idry fit the whole systemand there are only a few minor fit issues thati should be able to adjust for when i bolt it up for good. I did start the bike and it seemed to idle fine and sounded flat out rad!

Hopefully I'll have it all up and running by the weekend.

DC

 

[align=center]
[/align]
[align=center]
[/align]

 

sweet reply!

 

Wait. I don't understand. Just kidding. I Could not have hoped for a better reply than that...

Thanks for your help.

DC

 

Hey no problem, I've been in your situation! I could tell you the answer, but I figured the pictures would speak for themselves!

I lurk around here a lot and I'm trying to make an effort to give back. I barely have time to read everything let alone post. This forum has helped me plenty of times.

Good luck and don't be afraid to ask!