Case saver
#31
I wanted to do so with my KLX650 and with the 250. If it works I'd get some made up if cost effective. At least I have the bikes to do it. I have a WR250 rider that wants me to try to make a metal swing arm guard, because they tend to saw through the swing arm. It would be great to do one that would fit under the plastic slider. Problem - I don't have a bike or swing arm to do the work. Bummer. it's fun to make stuff and see if it can do the job.
#34
im still healing from the wipe out 3 weeks ago, ankle and ribs are still pretty tender. This and a few other winter projects planned since im keeping the bike in the garage to work on over the winter
#35
So these just came in today from german.....according to my measurements the left side should need very little trimming to fit. However the right side is going to need a relief cut for the clutch actuator
Last edited by Tacoma660; 11-03-2018 at 11:47 AM.
Thread
Thread Starter
Forum
Replies
Last Post