Anyone have any personal experience with these LSL Frame Sliders?

I thought they looked pretty cool, a little different from the average/typical frame slider.

http://www.spieglerusa.com/cfm/FrameSliders.cfm

 

The LSL's look nice. Fortunatley, never played with a fall over yet with sliders. Post some pics

 

interesting design. id like to see a test on those and how they keep the bike from spinning. kinda cool.

 

 

yes, they look nice. The claim on not spinning the ride on a get off I cannot picture yet. It is just delrin material for the slider. But the design is still cooler looking than what I just bought. Either way the tank will get the abuse over the frame with most sliders. Depending on the ride and speed at get off, etc.

 

Well I went out and bought the LSL sliders today. They look pretty darn good. I got the black ones.
I installed the left side this evening, went really well. The left somes with an aluminum bracket that bolts to the frame, There is an ofset on the bracket with a hole, which is where you install the puck. There is no cutting of plastics.
I was looking at the right side engine bolt and it looks a bit confusing. There is a bolt but it appears it screws into a threaded sleve with a few slots in it. Im assuming it is some type of..I dont know...double locking thread thingy???
Does the bolt and threaded sleve some out for the install? any insite from someone who did the install already whould be much appeciated..