A few ride pics
#1
A few ride pics
A small fishing dock in a nice little cove off the Bay of Fundy. It's a one way road comming down to the dock, steep hill comming down to.
Fishing boat anchored just inside the inlet
Parked on the dock
Left the dock and headed towards destination # 2, a small brook 15 or 20 Km away.
There are few deep spots, just beside/behind the bike the water probably would have been up to the gas tank or close to the bars, but most of it is about bottom of the frame deep. I crossed itwith no problems to get to the other side. It was my first water crossing in a brook with larger rocks in it and I was suprised how well it went, I was expecting to be sliding all over the place, but there was none of that.
On the other side
It was a good ride and nice sunny evening, it was good to get the ride in because it's suppose to rain the next 3 days.
Fishing boat anchored just inside the inlet
Parked on the dock
Left the dock and headed towards destination # 2, a small brook 15 or 20 Km away.
There are few deep spots, just beside/behind the bike the water probably would have been up to the gas tank or close to the bars, but most of it is about bottom of the frame deep. I crossed itwith no problems to get to the other side. It was my first water crossing in a brook with larger rocks in it and I was suprised how well it went, I was expecting to be sliding all over the place, but there was none of that.
On the other side
It was a good ride and nice sunny evening, it was good to get the ride in because it's suppose to rain the next 3 days.
#4
RE: A few ride pics
ORIGINAL: deej
Where was I when you got the 450? I gotta start paying more attention around here.
Where was I when you got the 450? I gotta start paying more attention around here.
#6
RE: A few ride pics
ORIGINAL: Iowaguy
must say, that is a sweet looking bike. did you ever uncork it? also, what state do you live in that will give you a plate on that thing? do you have high/low beam and a brake light?
must say, that is a sweet looking bike. did you ever uncork it? also, what state do you live in that will give you a plate on that thing? do you have high/low beam and a brake light?
I have a K&S DOT control switch for high/low, signals, kill, and horn that I still have to install along with the signal lights.
The bike is already setup for high/low and brake light in the tail light, you just have to wire it, I already did the brake light by installing a pressure switch in the master cylinder that replaces the factory banjo fitting, here's a picture...
Oh yea, I'm in New Brunswick, Canada. The bike was already plated for the road when I picked it up. You use to be able to change the title to street without an inspection, but that's getting rare here as they are starting to require an inpsection.
Thread
Thread Starter
Forum
Replies
Last Post