I have a 2011 4010 Trans 4x4 that I built from the ground up so to speak.
I never had a need to use 4 wheel drive but wanted to try it out after all of troubleshooting was complete after the build. Once I engaged 4x4 it would not come out of it. I have removed the cable and yet the drive shaft to the front still spins. I have manually moved the 2x4/4x4 selector on the gear case but nothing. Can someone steer me the right direction on how to get back to 2x4? The unit has had 4x4 engaged for a few months and I only drive it on my two acres at low speeds so I wasn't concerned for now.Recently I needed to drive our neighborhood horse trails to do some work and the frontend started getting louder and louder so I parked it until I can rectify the problem. thanks