Hey guys, I unhooked my tail and everything to replace it.when i hooked everything back up, the signals for whatever reason blew the fuse so i replaced it and now the signals dont work. when you turn the switch it wont even stay in the turning position. any idea what i can check? or where i can get a wiring diagram of the signal system.

FYI
as far as i know the only wires to the signal system are the one in the back (one black and one gray)

 

Sounds as though you may have burnt out your flasher. If you want a wiring diagram, a service manual is the best choice.

 

mark, how do I send a pdf photo of a page here, you know? Not off topic, since I think it pertains to his question.

 

and yes this is from my manual. hint, hint hotfocuson18s

 

Good question. Trial and error?

 

well just sucks the hind tit. Thanks mark. sheesh

edit: that still sucks the hind tit

 

Sorry.....

 

I purchased the bike preowned. I dont not have the manual. Does anyone have a diagram they can post so i can make sure everything is ok. 2004 zx10

 

I am still trying, you want a ladder or a pictoral diagram?