I finally found out why the bike wouldn't go over 4500 RPM and now I have a new question for everyone. The circlip on the needle jet was in the lowest possible setting, and this is wrong as the original location was in the center. I set that back to normal and the bike will rev out no problem at idle but still struggles under load but it will slowly crawl through the RPM's.

So here's my questions.

1. What are the stock mains supposed to be for this bike (southwestern Ontario, Canada)
2. Can anyone give suggestions as to what the mains should be for my bike with an aftermarket 4-1 exhaust and K&N style cone filters?


Thanks for your time,
Scott

 

No one even has any suggestions? I find that rather odd.

It would be much appreciated.

Thanks,
Scott