Removing the flywheel
#11
I had a local shop make a tool out of a long piece of scrap steel.
At one end there are two 9/16 bolts 57mm apart - both turned down at one end to just under 11mm so as to have a small shoulder above where they slip into the holes in the flywheel.
All for about 500 piso, which is about $12.
I should be ready to take the flywheel off later today without problem
At one end there are two 9/16 bolts 57mm apart - both turned down at one end to just under 11mm so as to have a small shoulder above where they slip into the holes in the flywheel.
All for about 500 piso, which is about $12.
I should be ready to take the flywheel off later today without problem
Thread
Thread Starter
Forum
Replies
Last Post
jasmix
Private 'Wanted' Classifieds
1
03-22-2007 05:00 PM