Has anyone removed the tool bag from the rear fender? If so what did you use to plug the holes?

 

My nomadic rack covers them up quite nicely since it actually uses them as mounting locations.

 

Same here, my Pro Moto rack uses the same holes. I then have my tool kit mounted underneath.

 

I plugged to stock tool bag holes with fasteners to attach a dirt-bike-gear.com tool bag. I then plugged the holes to attach the Wolfman Enduro tool bag.

 

The Nomadic rack uses 2 of the 4 holes as mounting holes. I used the old hardware (nut/bolt/washer) to cover the remaining 2 holes.

If I knew I was never going to use the holes again, I would have plugged them with a couple of the giant-flange SS pop-rivits I have.

 

Thanks guys, I don't plan on installing a rack, I used the original hardware for the small holes, but will have to improvise on the 2 large holes.

 

I used something like this...
http://www.clipsandfasteners.com/Doo...w_p/a11351.htm

 

Bcliff, do you use both the dirt bike gear and Wolfman bags?

 

I upgraded from the stock bag to the dirt-bike-gear bag to gain some additional room and recently have upgraded to the Wolfman for the same reason.

 

Cool. Thanks.
I bought the largest dirt bike gear bag. How does the wolfman compare to the dirt bike gear bag?