Not sure if this is what your after, but this mod looks pretty cool :D
Or you could maybe go for a small tail light like the DRC Edge

http://www.motohouston.com/forums/at...1&d=1344188825

black fender...plastic can be cut and you can always mount the lights and plate above, but not sure if it'll look good since the 09+ rear fender sits flatter

Very cool, I like the black.

I appreciate everyone's feedback and advice.

So back to the original question, does anyone know if the 06/07 rear fender is a direct bolt on to the 09?

highly doubt it. I believe the subframe is quite different in addiion to the body work.

but anything could be made to fit with enough work.

brilliant!! I didn't think to check the subframe part number. 2009+ have a /A appended to it.

Fender
 

so TJrockit

have you found a solution for the 2006 klx250 rear fender?

wondering what you have done.

I think I am going to just remove all that crap and mount my plate under the red tail light, keeping stock blinkers. it will not have a white light on the plate, but might still be ok

fenderworks
glenwood springs, co

Some aluminum, a drill and some nuts and bolts. I broke mine a few times.:D Then cut the black plastic off even with the bottom of the tail light made some bends and drilled some holes through the cross piece. I did three but would just go with two if I were to do it again.

http://turnsleft.smugmug.com/Other/2...IMGP0787-L.jpg

http://turnsleft.smugmug.com/Other/2...IMGP1362-L.jpg