Before I start to re-jet my tm 33, I was wondering is there a good way to get it apart on the bike or is it necessary to take it off first. Whatcha think??

 

I prefer to take the carb off of the bike and be thorough

edit: How can yo get a clean bottom, mid or wot if the carb is still unknown and has not been cleaned?

 

[quote=Dragone#19;406468]I prefer to take the carb off of the bike and be thorough

edit: How can yo get a clean bottom, mid or wot if the carb is still unknown and has not been cleaned?[/quote

It's a new carb from b blue and I need to go a couple of steps richer. If someone else has rejeted one they may have a good way to do it. Thats what is neat about this forum, someone has usually already found the best way to do the work.

 

Not a lot of room but you can rotate it around on the bike and get to all the jets. Pull the tank and remove the throttle cables from the carb, pull the bowl off on the pipe side.

 

I want a video of dragone replacing jets on our lil klx without removing it.....I GOT MONEY

Needle, sure.....jets....good lord, I would like to see that.

Just take off the carb and do it.

 

I ended up just pulling the carb off. Sure hope I get it right the first time, I'd hate to go through this two or three times.