Dyno Results
#1
Dyno Results
I got my bike Dyno'd today.
I was happy enough with the bike but just thought I'd get an expert to check if it was jetted correctly.
Results are
[IMG][/IMG]
[IMG][/IMG]
I had a knobby on so the figures may be a little inaccurate.
According to "the man" the jetting is fine.
I believe the solid line to be the HP and the dotted line the fuel ratio.
Anyone who knows about this stuff, tell me what you think.
I'm not 100% sure that this guy was giving it his best.
He might have been just busy but I just find it hard to believe that my "seat of the pants" job was as good as it could be.
He said he didn't need to adjust or change anything.
It's got 300 kit, Mikuni pumper, Big gun full system and no air box lid.
I had it set with a 142.5 main, needle on 3rd clip and what ever pilot jet Bill ships em with. (can't remember the number)
#7
RE: Dyno Results
Thanks for posting ,quick couple of questions.
Did they give you a print out of rpm instead of speed?
And also a torque plot I'm just trying to see some ignition curves with those.
What gear was the pull in?
Thanks Kevin
Did they give you a print out of rpm instead of speed?
And also a torque plot I'm just trying to see some ignition curves with those.
What gear was the pull in?
Thanks Kevin
#8
RE: Dyno Results
ORIGINAL: kgwld1
Thanks for posting ,quick couple of questions.
Did they give you a print out of rpm instead of speed?
And also a torque plot I'm just trying to see some ignition curves with those.
What gear was the pull in?
Thanks Kevin
Thanks for posting ,quick couple of questions.
Did they give you a print out of rpm instead of speed?
And also a torque plot I'm just trying to see some ignition curves with those.
What gear was the pull in?
Thanks Kevin
I'll have to ask about torque, gear etc.
Thread
Thread Starter
Forum
Replies
Last Post