Another 2 Bros report...
Thread Starter
|
Member
1st Gear Member
Joined: Nov 2006
Posts: 68
From:
Another 2 Bros report...
Well, after waiting literally months for a Muzzy system to ship, I gave up, and decided to pull the trigger on the 2 Bros Slip On system. Time from order to arrival was about a week and some change, totally acceptable. I ordered direct from their website. www.twobros.com
Last night, went to do the install. Product looks great, nicely packaged, well put together. It should work well, however, I wouldn't know yet.The problem, similar to another recent posting, I was missing 1 absolutely key part - the ring that holds the mid pipe to the actual can. Not possible to install without this piece. Also not a piece you can just run to the hardware store and find a replacement for. Frustrating.
Called the company today, they were very apologetic, and based on their reaction, I suspect mine was not the first call they recently had along these lines. At any rate, they are shipping the part to me, should be here in a day or two. Decent response to the problem, however, it shouldn't have happened in the first place.
I recall a recent posting by another frustrated klx'er, and I must now join that club, as well as justify the complaints about quality control. The "system" basically consists of 4 things -the can, the mid pipe, the "x-lite ring" to connect the two (which I'm missing), and a bag of nuts and bolts to hook it all up. How hard is it to make sure that 4 things are in the box?
On a side note, I briefly fired up the bike, with only the header/mid pipe installed. Loud. (hehehe)
Last night, went to do the install. Product looks great, nicely packaged, well put together. It should work well, however, I wouldn't know yet.The problem, similar to another recent posting, I was missing 1 absolutely key part - the ring that holds the mid pipe to the actual can. Not possible to install without this piece. Also not a piece you can just run to the hardware store and find a replacement for. Frustrating.
Called the company today, they were very apologetic, and based on their reaction, I suspect mine was not the first call they recently had along these lines. At any rate, they are shipping the part to me, should be here in a day or two. Decent response to the problem, however, it shouldn't have happened in the first place.
I recall a recent posting by another frustrated klx'er, and I must now join that club, as well as justify the complaints about quality control. The "system" basically consists of 4 things -the can, the mid pipe, the "x-lite ring" to connect the two (which I'm missing), and a bag of nuts and bolts to hook it all up. How hard is it to make sure that 4 things are in the box?
On a side note, I briefly fired up the bike, with only the header/mid pipe installed. Loud. (hehehe)
Junior Member
Joined: Aug 2007
Posts: 3
From:
RE: Another 2 Bros report...
I am new to the forum (so I apologize if I don’t’ do this right) and I just purchased a 07 KLX 250 a few weeks ago and lets just say I am mechanically challenged J I looked at several slip ons and finally decided to go with the 2 Brothers (mostly because of the M7 VALVE that allows you to add a power tip which I may actually take advantage of). I called their support line before ordering because I had a few questions and they answer all my questions (much more help than the local dealer) so I told him I would order one.
The representative at 2 Bros suggested I call Star Cycle (800-990-BIKE @ http://www.starcycle.com) to get a discount. I called them as soon as I got off the phone and they were extremely helpful as well. I called Friday in the afternoon (which means it didn’t ship until Saturday) and it arrived today (Tuesday) which was much quicker than what I expected. He checked local distributors and found one close to me (in Ohio). Couldn’t ask for more, and on top of all that, the total cost was $326 delivered (a heck of a lot cheaper than the dealer or on the web site)!
I just got done putting it on a few minutes ago. No missing parts, no problem. Only took about 20 minutes (which is good considering I am mechanically challenged JLouder than I thought it would be but sounds great and runs much better (may be too loud to drive around the neighborhood so I may get a P3 Power Tip). I am waiting for the new KDX snorkel (which should arrive tomorrow) then I plan to take my baby to the dealer to get the 13 tooth front sprocket and to get it re-jetted (way too much for me to do).
The representative at 2 Bros suggested I call Star Cycle (800-990-BIKE @ http://www.starcycle.com) to get a discount. I called them as soon as I got off the phone and they were extremely helpful as well. I called Friday in the afternoon (which means it didn’t ship until Saturday) and it arrived today (Tuesday) which was much quicker than what I expected. He checked local distributors and found one close to me (in Ohio). Couldn’t ask for more, and on top of all that, the total cost was $326 delivered (a heck of a lot cheaper than the dealer or on the web site)!
I just got done putting it on a few minutes ago. No missing parts, no problem. Only took about 20 minutes (which is good considering I am mechanically challenged JLouder than I thought it would be but sounds great and runs much better (may be too loud to drive around the neighborhood so I may get a P3 Power Tip). I am waiting for the new KDX snorkel (which should arrive tomorrow) then I plan to take my baby to the dealer to get the 13 tooth front sprocket and to get it re-jetted (way too much for me to do).
Senior Member
1st Gear Member
Joined: Jul 2007
Posts: 128
RE: Another 2 Bros report...
I just received My 2 Brothers slip on yesterday and it was missing the X-ring clamp too..grrr. I called 2 Brothers and they are shipping Me the part.
It looks nice & is very light! Can't wait to put it on.
It looks nice & is very light! Can't wait to put it on.
Senior Member
1st Gear Member
Joined: Mar 2007
Posts: 398
From:
RE: Another 2 Bros report...
ORIGINAL: ITOxymoron
I am new to the forum (so I apologize if I don’t’ do this right) and I just purchased a 07 KLX 250 a few weeks ago and lets just say I am mechanically challenged J I looked at several slip ons and finally decided to go with the 2 Brothers (mostly because of the M7 VALVE that allows you to add a power tip which I may actually take advantage of). I called their support line before ordering because I had a few questions and they answer all my questions (much more help than the local dealer) so I told him I would order one.
The representative at 2 Bros suggested I call Star Cycle (800-990-BIKE @ http://www.starcycle.com) to get a discount. I called them as soon as I got off the phone and they were extremely helpful as well. I called Friday in the afternoon (which means it didn’t ship until Saturday) and it arrived today (Tuesday) which was much quicker than what I expected. He checked local distributors and found one close to me (in Ohio). Couldn’t ask for more, and on top of all that, the total cost was $326 delivered (a heck of a lot cheaper than the dealer or on the web site)!
I just got done putting it on a few minutes ago. No missing parts, no problem. Only took about 20 minutes (which is good considering I am mechanically challenged JLouder than I thought it would be but sounds great and runs much better (may be too loud to drive around the neighborhood so I may get a P3 Power Tip). I am waiting for the new KDX snorkel (which should arrive tomorrow) then I plan to take my baby to the dealer to get the 13 tooth front sprocket and to get it re-jetted (way too much for me to do).
I am new to the forum (so I apologize if I don’t’ do this right) and I just purchased a 07 KLX 250 a few weeks ago and lets just say I am mechanically challenged J I looked at several slip ons and finally decided to go with the 2 Brothers (mostly because of the M7 VALVE that allows you to add a power tip which I may actually take advantage of). I called their support line before ordering because I had a few questions and they answer all my questions (much more help than the local dealer) so I told him I would order one.
The representative at 2 Bros suggested I call Star Cycle (800-990-BIKE @ http://www.starcycle.com) to get a discount. I called them as soon as I got off the phone and they were extremely helpful as well. I called Friday in the afternoon (which means it didn’t ship until Saturday) and it arrived today (Tuesday) which was much quicker than what I expected. He checked local distributors and found one close to me (in Ohio). Couldn’t ask for more, and on top of all that, the total cost was $326 delivered (a heck of a lot cheaper than the dealer or on the web site)!
I just got done putting it on a few minutes ago. No missing parts, no problem. Only took about 20 minutes (which is good considering I am mechanically challenged JLouder than I thought it would be but sounds great and runs much better (may be too loud to drive around the neighborhood so I may get a P3 Power Tip). I am waiting for the new KDX snorkel (which should arrive tomorrow) then I plan to take my baby to the dealer to get the 13 tooth front sprocket and to get it re-jetted (way too much for me to do).
Second, thanks for the info on Star Cycle. I called earlier today and they had one in stock and the guy said he could have it to me on Friday! This is after I got screwed by my dealer. I ordered one when I brought my bike in for the first service. I checked again in a week and a half and the guy in parts told me it was backordered but would be in around the beginning of August. I called again today as it'sbeen a month and the guysaid that he didn't even see one on order for me!!!! [:@]What kind of sh#t is that! I do know where I won'tbe spending any more of my money. Anyway, thanks again and I hope it comes on Friday and not missing any parts.
Senior Member
1st Gear Member
Joined: Mar 2007
Posts: 170
From: HUDSON NC
RE: Another 2 Bros report...
man that sucks for all you guys. i got mine with all parts and installed it cranked it up and ran it up and down the road about midnight to let the neighbors know it was installed. that was back in like feb. or something. i had to wait over a month for it to ship though. they told me it was still on the assembly line. paid approx. 320 shipped. i loved it and i am sure you will to after you get it all together. fits perfect and easy assembly. 
Senior Member
Joined: Aug 2007
Posts: 241
From:
RE: Another 2 Bros report...
Hey guys,
Another Noob so sorry if this is a stupid question, but do you have to re-jet with the slip-on systems? Interested in getting a TB pipe but am trying to figure out other costs that might be coming along with it.
Thanks for any input.
Another Noob so sorry if this is a stupid question, but do you have to re-jet with the slip-on systems? Interested in getting a TB pipe but am trying to figure out other costs that might be coming along with it.
Thanks for any input.
Senior Member
1st Gear Member
Joined: Jul 2007
Posts: 128
RE: Another 2 Bros report...
HawaiiRider -- Some afternoon take Your snorkel off of Your air box lid, then put the lid back on, and go for a ride...don't leave it that way without rejetting because it will make the engine run leaner & hotter. When You feel the extra umph..from removing the snorkel, just think if fuel was added too (jet kit). That will give You a taste of how restricted the bike is in stock form. If You don't feel like doing the jetting Yourself most shops should be able do it for You for under $60 labor.
Your Humble Moderator/Admin
Joined: Nov 2005
Posts: 21,060
From: Washington
1st Gear Member
RE: Another 2 Bros report...
ORIGINAL: ITOxymoron
I am new to the forum (so I apologize if I don’t’ do this right) and I just purchased a 07 KLX 250 a few weeks ago and lets just say I am mechanically challenged J I looked at several slip ons and finally decided to go with the 2 Brothers (mostly because of the M7 VALVE that allows you to add a power tip which I may actually take advantage of). I called their support line before ordering because I had a few questions and they answer all my questions (much more help than the local dealer) so I told him I would order one.
The representative at 2 Bros suggested I call Star Cycle (800-990-BIKE @ http://www.starcycle.com) to get a discount. I called them as soon as I got off the phone and they were extremely helpful as well. I called Friday in the afternoon (which means it didn’t ship until Saturday) and it arrived today (Tuesday) which was much quicker than what I expected. He checked local distributors and found one close to me (in Ohio). Couldn’t ask for more, and on top of all that, the total cost was $326 delivered (a heck of a lot cheaper than the dealer or on the web site)!
I just got done putting it on a few minutes ago. No missing parts, no problem. Only took about 20 minutes (which is good considering I am mechanically challenged JLouder than I thought it would be but sounds great and runs much better (may be too loud to drive around the neighborhood so I may get a P3 Power Tip). I am waiting for the new KDX snorkel (which should arrive tomorrow) then I plan to take my baby to the dealer to get the 13 tooth front sprocket and to get it re-jetted (way too much for me to do).
I am new to the forum (so I apologize if I don’t’ do this right) and I just purchased a 07 KLX 250 a few weeks ago and lets just say I am mechanically challenged J I looked at several slip ons and finally decided to go with the 2 Brothers (mostly because of the M7 VALVE that allows you to add a power tip which I may actually take advantage of). I called their support line before ordering because I had a few questions and they answer all my questions (much more help than the local dealer) so I told him I would order one.
The representative at 2 Bros suggested I call Star Cycle (800-990-BIKE @ http://www.starcycle.com) to get a discount. I called them as soon as I got off the phone and they were extremely helpful as well. I called Friday in the afternoon (which means it didn’t ship until Saturday) and it arrived today (Tuesday) which was much quicker than what I expected. He checked local distributors and found one close to me (in Ohio). Couldn’t ask for more, and on top of all that, the total cost was $326 delivered (a heck of a lot cheaper than the dealer or on the web site)!
I just got done putting it on a few minutes ago. No missing parts, no problem. Only took about 20 minutes (which is good considering I am mechanically challenged JLouder than I thought it would be but sounds great and runs much better (may be too loud to drive around the neighborhood so I may get a P3 Power Tip). I am waiting for the new KDX snorkel (which should arrive tomorrow) then I plan to take my baby to the dealer to get the 13 tooth front sprocket and to get it re-jetted (way too much for me to do).
) and he did an awesome job. I would recommend having the shop doing the jetting, but you should b able to change out the front gear pretty easy yourself, but then again, if its in the shop, I suppose it would take them all of 5 minutes to do it for you. Again welcome and have fun, because as we all know, if your riding the KLX you can't help but have fun.[sm=smiley20.gif]