kx250 jetting
#1
kx250 jetting
howdy all - i just got a 2004 kx250, am putting a fmf fatty pipe and turbinecore2 silencer on as the old was all smashed apart. question is jetting.... got this chart off the fmf site:
Main Jet - 165
Pilot Jet - 52
Needle - STOCK
Needle Position - 2ND
Power Jet - STOCK
Air Screw - 1.5
so i'm planning to use this as my base point, anybody have any experience on if i should use something else to start with? i'll be at about 3200 ft, and temps 50 to 85 here. so also wondering what effect my altitude and temp would have on those base settings? thanks and cheers to all
Main Jet - 165
Pilot Jet - 52
Needle - STOCK
Needle Position - 2ND
Power Jet - STOCK
Air Screw - 1.5
so i'm planning to use this as my base point, anybody have any experience on if i should use something else to start with? i'll be at about 3200 ft, and temps 50 to 85 here. so also wondering what effect my altitude and temp would have on those base settings? thanks and cheers to all
Thread
Thread Starter
Forum
Replies
Last Post
noimad1
KX250 & KX250F
48
02-10-2008 07:09 AM
freestyle250r
PRIVATE For Sale / Trade Classifieds
3
08-27-2006 04:34 PM