Now that is nice out again, I'm back in the fulll swing of riding. I still have a few parts to replace and my highside will be erased from the bike... I am looking pretty serious into running black anodized MDR engine convers instead of going with stockers? Has anyone ran these?

http://www.mdrindustries.net/GSXR-EngineCovers/

 

what side were you looking to replace....i know that woodcraft makes a left side engine cover that you can get black and it also has a slider on it as well that you can get black...it looks pretty good heres a link to what it looks like http://www.woodcraft-cfm.com/Scripts...dproduct=17746

 

If I am going to go notstock (yes that is a pun from this forum...couldn't resist) then I am going to replace both covers. Esp if I am going to go black... I like em both but the woodcraft's are about 35 bucks more.. but offer better protection...

 

ya i know looks better if you match both sides...i am just waiting for the woodcraft to make the right side

 

well i was checking the site out again and they do make a black left side engine cover http://www.woodcraft-cfm.com/Scripts...dproduct=17770 they dont have a pic of the black one yet but here is the link for the other one http://www.woodcraft-cfm.com/Scripts...dproduct=17769 this should be what the black one will look like

 

Either one should be a good upgrade over stock. The side covers will be stronger since they are not a cast cover. This could save expensive internals.

Mike