Misfire over 3000 revs
#1
Misfire over 3000 revs
Hi, new to the site so hi to everyone, looking for some advise, just purchased a zzr600, 1990' starts fine however won't rev above 3000 then misfires, when left ticking over you can attempt to rev and does the same again, I have had the plugs out and cleaned and checked the air filter element, looks like its had better days as half is missing? Am going to put new plugs and filter to see if that would help, just looking for further advise, bike has been unused for around 6 months
Cheers Ken
Cheers Ken
#7
Thanks, I have a new battery fitted and charging system working okay, will remove the carbs and clean as previously suggested, new plugs and air filter at the end of the week, will update then, thanks for all the replies
Cheers Ken
Cheers Ken
#8
I think it fuel related, new plugs and filter done, starts ok, tick over lumpy, once warm it will rev to around 4000, on the second rev it just dies a death, fairly sure it's fuel , looking for any advise on carb removal, I had a quick look and my only concern was the throttle cable, awaiting workshop manual arriving but inpatients getting the better of me, any advise would be welcome
Regards Ken
Regards Ken
#9
Hi , thanks for all the advise, stripped down carbs today, all were full of rusty jelly and all jets blocked, cleaned and reassembled , fired up a treat, time to clean up and get it back on the road, thanks again to all who replied
Cheers Ken
Cheers Ken
Thread
Thread Starter
Forum
Replies
Last Post