RE: Torque specs question.
Chris you can buy only the shims you need.... like he said they are like 11-12$ a piece.... or the kit, so you know you will have everything you need.
|
RE: Torque specs question.
I didnt know what sizes I needed until I pulled and measured the ones that were already installed.
|
Thanks
|
Originally Posted by EMS_0525
(Post 109903)
Valve clearance :
Intake: 0.10-0.19 mm exhaust: 0.15-0.24mm cylinder head cover bolts: 7.8Nm (0.8kg-m, 69 in/lbs) if you adjust them, the camshaft cap bolt torque is : 12n-m (1.2kg-m, 8.5 in/lbs) I think thats all you would need. (just happen to have the service manual right here):D Fyi, 12n-m = 106in-lb not 8.5. |
Good catch!
12 n-m is about 8-1/2 ft-lb., too low for any ft-lb torque wrench to be accurate. So an inch-lb wrench is a must for motorcycle engine work. |
All times are GMT. The time now is 07:23 AM. |
© 2024 MH Sub I, LLC dba Internet Brands