|
Originally Posted by Lutz
(Post 452160)
I think I just used a 1/4" drive, 6 point, deep well socket with an appropriate extension. It wasn't perfectly in-line due to frame tube interference - in which case you'll really want a 6 point socket rather than a 12 point. If you're using a 3/8" drive, I don't think it will work - there'll be too much interference with the frame tube.
Oh, and it's not a 3/8" nut...it's metric. I can't remember if this nut is an 8mm, 9mm, or 10mm. Everything is metric on this bike - if you don't have metric tools, stop and get some, or you'll inevitably end up rounding off some nuts or bolts. Good luck. Rogers, I think Lutz is right, if I recall I used a deep socket with a wobble extension, which allowed me to get to the nut while avoiding the frame. A bit of a pain, but it was doable. Lutz, negatory, I had no idea about the new part, the one I got was the old design. By the way, I noticed on CheapCycleParts that the part shows as being 'replaced' by a new part number, this must be what that's all about. I wish I knew... Good luck Rogers, and let us know what happened. |
Sorry about the delay. Yes, the bolts are 8mm and that nut is 10mm. I had to use a wiggler and a short 8mm socket on a 1/4inch drive. Lutz, I've read your other thread and my replacement part is the older style from 2006/2007 bikes
|
| All times are GMT. The time now is 06:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands