anyone know correct plug gap?
#1
anyone know correct plug gap?
grrrrr
wife moved my owners manual and i cant find it.
bike has lost a lot (10MPH) off the top end. going trough everything right now to see if maybe i just didnt gain 15lbs or something lol
got the plug out so might as well check the gap.
wife moved my owners manual and i cant find it.
bike has lost a lot (10MPH) off the top end. going trough everything right now to see if maybe i just didnt gain 15lbs or something lol
got the plug out so might as well check the gap.
#4
hey now i run things in the house lol
thanks
just cleaned the air filter and holy crap how can an engine breath through this thing? was using my compressor to blow/dry the thing and at 100 psi i could barely feel anything on the other side
thanks
just cleaned the air filter and holy crap how can an engine breath through this thing? was using my compressor to blow/dry the thing and at 100 psi i could barely feel anything on the other side
#5
Toilet seat up at my house is a set up for the wifey to go ker-SPLASH! if she's not paying attention lol.
I can make my uni filter flow nada if I get overzealous w/ the spray on filter oil. I miss using K&N filters, the clean up is sooo much easier.
I can make my uni filter flow nada if I get overzealous w/ the spray on filter oil. I miss using K&N filters, the clean up is sooo much easier.
#6
next rip to the bike shop im gonna see what they got for filters
well all checked out ok. plug reads fine gap correct. filter cleaned and lightly oiled. oil level good rear tire presure was down a bit.
guess i'll find out in the morning if the tire pressure and clean air give me my top end back.
i hear a little ticking n a cold start could be valve adjustment time.
well all checked out ok. plug reads fine gap correct. filter cleaned and lightly oiled. oil level good rear tire presure was down a bit.
guess i'll find out in the morning if the tire pressure and clean air give me my top end back.
i hear a little ticking n a cold start could be valve adjustment time.
Thread
Thread Starter
Forum
Replies
Last Post