Stock Exhaust mod
#1
Stock Exhaust mod
I saw a post about someone modified their stock exhaust pipe with an angled flange. Now I cant seem to find that post. The person used some kind of hardware part that looks like this: http://imgp3.en.makepolo.net/m/262/9...ef5bc59f5b.jpg
I am trying to find this part. Does anyone know what the part is or a link to the modified exhaust post?
I am trying to find this part. Does anyone know what the part is or a link to the modified exhaust post?
#2
Certain generations had removable butt plates on the exhaust (my 2009 did not).
If yours does you'll see a screw holding it on in the back of the exhaust. You can buy those angled tips off ebay for cheap and put it on.
If yours does you'll see a screw holding it on in the back of the exhaust. You can buy those angled tips off ebay for cheap and put it on.
#5
Last edited by rgmr250; 06-23-2015 at 08:36 PM.
#6
So since I cant find the post of the flange, I decided to model one in 3-D and now I am going to have it printed at Shapeways - 3D Printing Service and Marketplace
Here is a short video of what the Exhaust tip will look like. Going to cost $45.
https://goo.gl/photos/E2pLw4u3M9XcpF3CA (hit the play button)
Here is a short video of what the Exhaust tip will look like. Going to cost $45.
https://goo.gl/photos/E2pLw4u3M9XcpF3CA (hit the play button)
#7
Seems cheap & convenient to print something up. Nice.
What will it be made out of? You have to supply them with a cad file?
I created a turn down tip with an aluminum plate & a leftover copper elbow piece.
Post a picture when it's finished.
What will it be made out of? You have to supply them with a cad file?
I created a turn down tip with an aluminum plate & a leftover copper elbow piece.
Post a picture when it's finished.
Thread
Thread Starter
Forum
Replies
Last Post